Friction press operation procedure
1. Wear and wear protective equipment.
2. Observe the general rules for safe operation of stamping workers.
3, according to the lubrication requirements of the machine refueling.
4, before loading the mold must check the mold closed height can be installed within the allowable range. Adjust the punch up and down to keep it within the specified safety range.
5, the mold should be fastened firmly. After several parts of pressure test, the mold should be tightened again to avoid accidents.
6. When working, holding the operating lever should be used with a steady force. It must not be subjected to violent pressure to avoid strong impact on the hammer head and bed, so as to avoid accidents.
7. When the flywheel rotates, it is not allowed to make machine adjustments or install molds and other work.
8. When two people are working on the press at the same time, their spirits must be concentrated. Before punching down, they must say hello to make the action consistent. They must not work in dangerous areas.
9. When you live, you can only use the steel plate with a size of 220mm x 200mm.
10. After the work is completed, the punch will be smoothly placed and the cars will be shut down in order.
11. The accident should be kept on site and reported to the relevant department.
Looking forward to your inquiry for this friction press screw press