Call us at 0086 13869856893

News Detail

Welcome to our website!

screw press machine punch press machine manufacturers

2018-03-26 09:32:09

screw press machine
screw press machine

punch press machine manufacturers
punch press machine manufacturers
screw press machine
punch press machine manufacturers
screw press machine punch press machine manufacturers

Screw press machine work preparation
1.check the press mold should be installed correctly, fastened firmly. The resultant center of stampings should coincide with the center of the press as far as possible. The die support area must not be less than one-third of the punch bottom area.
2. The press clears debris from the punch stroke space and mold space.
3. After the press is idle to run the test or replace the mold or adjust the closing height, the first stroke of the punch is only allowed to manually move the flywheel. Check and confirm that the mold closing height and the position of the screw are adjusted before starting the equipment.
4. The flywheel and the clutch must be disengaged to start the main motor. The direction of rotation of the flywheel must be the same as the direction of the flag.
Looking forward to your inquiry for this screw press machine punch press machine manufacturers